Setup Slave Fixtures; Sample Master-Slave Setup And Linking (Visual Guide) - Chauvet Thruster User Manual

S e t u p S l a v e F i x t u r e s
1. Set DMX ADD ASSIGN DIP-switch #10 to the "Off" position.
2. Set thefixture number in the chain using DIP-switches 1 through 5 of the DMX ADD ASSIGN DIP-
switches.
3. Connect the end of the cable coming from the first fixture which will have a (female) 3 pin
connector to the DMX IN input connector of the Slave fixture consisting of a (male) 3 pin
connector. Continue the loop from DMX OUT to DMX IN.

Sample Master-Slave Setup and Linking (Visual Guide)

The following system example consists of:
• 5 total fixtures
• Master fixture will run the "Flow from left to right" pattern in Sound mode.
1. MASTER Fixture
UNIT ASSIGN
DMX ADD
ASSIGN
Important!
In Master-Slave use the LINK Out
instead of the DMX Out connector when
jumping from the Master fixture!
2. SLAVE Fixture
UNIT ASSIGN
DMX ADD
ASSIGN
3. SLAVE Fixture
UNIT ASSIGN
DMX ADD
ASSIGN
4. SLAVE Fixture
UNIT ASSIGN
DMX ADD
ASSIGN
5. SLAVE Fixture
UNIT ASSIGN
DMX ADD
ASSIGN
Thruster User Manual
Sound
Auto
1 2 3 4 5 6 7 8 9 10
Sound
Auto
1 2 3 4 5 6 7 8 9 10
Sound
Auto
1 2 3 4 5 6 7 8 9 10
Sound
Auto
1 2 3 4 5 6 7 8 9 10
Sound
Auto
1 2 3 4 5 6 7 8 9 10
11
Link Output
DIP-switches 1 ~ 5 are used to set the total
number of fixtures in the system. DIPswitch
# 6 sets Sound or Auto
DIP-switches # 1 ~ 5 are used to select the running built-in
pattern for the entire system, NOT to address the fixture like in
the slave fixtures following. In this instance refer to the Table of
DIPswitch settings in the page following to choose a programmed
pattern. The master fixture defaults to Fixture address # 1
DMX Output
In Slave fixtures, DIP-switches # 1 ~ 5 are used to set the
Fixture number. DIP # 10 needs to be in the OFF position.
Remember that the master fixture's default address is # 1
so you will need to start at # 2
Operating Instructions
Use certified DMX XLR cable
DMX Input
2006-10-10 13:31
/