Advertisement
5
Fixing and exchange
5.1
Base plate
The motor control units are attached to the sub-floor via their
respective basic modules. The following section describes how
you attach these basic modules and establish a connection with
the flat cable.
The diagrams only show one type of basic module. The other
types are installed in the same way.
The terminal assignment of the plugs, the connection of the
loads and the energy supply or signal routing can be found in
the descriptions of the individual types of motor control units.
All the electrical installations and connections
may only be carried out by qualified personnel.
The
appropriate
WARNING
regulations must be observed.
Dimensions and sketch of the installation
The sketch below indicates the relevant dimensions in mm for
the installation (the example shows the podis
the dimensions of the other variants are identical).
The sub-floor must be flat and portable. It must also be
prepared if necessary for attaching the motor starter.
Wieland podis
system
Manual V 1.03 / ref. no. 00.000.0059.0 / 28.03.2001
safety
and
accident
MFI base plate,
Bild: 0010160
Advertisement
