Advertisement
The following I/O byte structure is produced for each of the
three device types:
- Reverse contactor (MRC):
- Direct starter, 2 motors:
- Frequency inverter:
All the necessary parameterisation for the basic device as well
as the extension devices can be carried out via the
configuration software (e.g. Step 7). The inputs are carried out
via the menu item "Parameterisation". More detailed information
about the parameter settings can be found in section 6.6
"Parameterisation".
The item number for ordering the GSD file can be found in the
appendix.
4.4.2
Monitoring and protective devices
All the monitoring and protective devices required for the
connected loads are integrated in the motor control units
(further explanations can be found in the performance data of
the respective type of motor control unit). Additional devices are
not required.
4.5
Supply terminals
The energy supply for both the connected loads and the control
system is carried out solely via the energy bus podis
the relevant data can be found in part 1 of the manual.
Wieland podis
system
Manual V 1.03 / ref. no. 00.000.0059.0 / 28.03.2001
4 byte inputs; 2 byte outputs
7 byte inputs; 2 byte outputs
4 byte inputs; 4 byte outputs
Technical data
Motor control unit MFI
CON. All
Advertisement
