Maintenance - Yetter TITAN 2967-033A Operator's Manual

I
MPORTANT: Please check the amount of travel that the Residue Manager has before going to the field.
I
MPORTANT: Check for clearance with the residue manager wheels. If the residue manager wheels can
make contact with the frame, tires, or hitch the Titan™ Residue Manager could be damaged.
Once the knives are at the desired depth, the machine must be leveled. A low front end will cause the front
knives to be in the ground deeper than the rear knives. With the knives in the soil, measure distance "A"
and "B" from level ground to the bottom of the frame – THIS DISTANCE MUST BE THE SAME. Once the
distance is obtained, step back approximately 50 feet and view the machine. The applicator should appear
level to the ground. If not, make certain the ground is level. The applicator can be leveled by changing the
position of the hitch clevis.
Set the coulter depth. The coulters are adjusted independent of the A. A. knives. Loosen the set screws on
the mounting bracket and slide the coulter shaft up or down to the desired height.
Do not run the coulters any deeper than what is needed to cut the residue. Running the coulters deeper
than necessary increases coulter wear. Coulters set too deep will decrease berm height by prefacturing the
soil in front of the knife.
Regularly inspect the residue manager for loose or worn parts. Repair and replace as
needed.
Storing the Equipment
Store the machine in an area away from human activity
Store machine in RAISED position.
Install service locks on all wheel cylinders.
At the end of the season, the machine should be thoroughly inspected and prepared for
storage. Repair or replace any worn or damaged components to prevent down time at the
start of the next season. Store machine under cover with all parts in operating condition.
 Clean machine thoroughly to remove all dirt, debris and crop residue, which would
hold moisture and cause rusting.
 Inspect machine for worn or broken parts. See your Yetter Farm Equipment dealer
during the off-season so that parts or service can be acquired when machine is not
needed in the field.
 Lubricate bearings as outlined in the Lubrication section
 Paint all parts which are chipped or worn and require repainting.
 Store machine in a clean, dry place with the planting unit out of the sun.
 If the machine cannot be stored inside, cover with a waterproof tarpaulin and tie
securely in place.
 Do not allow children to play on or around the machine
OPERATION
Level applicator as shown below.

MAINTENANCE

9