Advertisement
CAUTION: Where rocks are present the residue manager should be set in the
"float" position, not locked down.
Adjust the residue manager to move crop residue aside and not move any soil.
Adjustments to the residue manager may have to be made when changing field
conditions and type and amount of residue. Use the handle for leverage when changing
depth settings.
"FLOAT SETTINGS"
Install the adjustment pin below the combo arm.
To raise the wheels, lift the 2967-295 and move the
adjustment pin up.
To lower the wheels, move the adjustment pin
down.
"RIGID SETTING"
Install the adjustment pin through the combo arm.
To raise the wheels, lift the 2967-295-combo arm
to the desired position and insert the pin.
To lower the wheels, lower the combo arm to the
desired position and insert the pin.
ROW CLEANER DO'S AND DON'TS
1. DO NOT move soil; Residue Managers are designed to move crop residue
only.
2. DO NOT operate at slow speeds, ground speed affects how aggressive the
spoke wheels are; operate at sufficient speed (4-6 mph) to maintain good
residue flow.
3. DO NOT expect 100% of crop residue to be cleared, it is not necessary and
would necessitate engaging the soil. The width of path cleared depends on
ground conditions, depth setting and ground speed.
4. DO expect to see wheels occasionally quit turning, indicates ideal (shallow)
setting which is not moving soil.
5. DO adjust toolbar frame height and drawbar to "level" correctly. Very
important to ensure residue manager will follow ground contours properly.
8
OPERATION
Advertisement
