Introduction; Purpose; Scope; General Description - Upright MX15 Service & Parts Manual

I
NTRODUCTION
1.1 I
NTRODUCTION
1.2 G D
ENERAL
DO NOT use the work platform without guardrails properly assembled and in
place.
MX15/19
P
URPOSE
The purpose of this service and parts manual is to provide instructions and illustrations for the
operation and maintenance of the MX15/19 manufactured by UpRight, Inc. of Selma, California.
S
COPE
The manual includes procedures for proper operation, maintenance, adjustment, and repair of
the MX15/19 as well as recommended maintenance schedules and troubleshooting.
ESCRIPTION
The MX15/19 consists of the platform, controller, elevating assembly, power module, control
module, and chassis.
W A R N I N G
!
P
LATFORM
The platform has a reinforced steel
floor, 39.5 inch (.99 m) high guardrails
with midrail, 6 inch (152 mm) toeboards,
and an entrance gate at the rear of the

platform.

P C
LATFORM ONTROLLER
The platform controller contains the
controls to operate the machine. It is
located at the front of the platform. A
complete explanation of control func-
tions can be found in Section 2.
E A
LEVATING SSEMBLY
The platform is raised and lowered by
the elevating assembly. The hydraulic pump, driven by an electric motor, powers the cylinder.
Solenoid operated valves control raising and lowering.
!
1.Platform

2.Platform Controller

3.Elevating Assembly

4.Chassis Controls
5.Chassis
060569-004

Figure 1-1: MX15/19 Work Platform

2
1
3
4
5
Page 1-1