Table of Contents
Advertisement
L AM P I N ST ALL AT I O N ( ART - 25 2W )
1)
Remove the lamp back cover by
removing the 4 screws located on rear
of the head as illustrated (S1).
2)
With lamp socket plate out and the
lamp accessible, if replacing the lamp,
remove old lamp first.
3)
Holding the new lamp by its base, align
the small pin on the lamp with the small
hole in the socket and insert the lamp
squarely until the retaining clips on the
lamp socket secures the lamp tightly.
4)
Clean the glass/envelope of the bulb
with an alcohol wipe or equivalent.
5)
Holding the lamp socket plate, insert
the tip of the lamp into the fixture with
extreme care. Navigate the lamp all the
way until it reaches the reflector and the
lamp base plate touches the bottom
plate of the fixture.
6)
Align the screw holes and fasten the
screws back onto the lamp bank cover.
7)
If you are replacing the lamp, you may want to log the fixture hours in order to track the lamps use.
Navigate to the {FhrS} on the menu display to obtain this information.
Power
• To determine the power requirements for a particular fixture, see the label affixed to the back plate
of the fixture or refer to the fixture's specifications chart.
• A fixture's listed current rating is its average current draw under normal conditions.
• All fixtures must be powered directly off a switched circuit and cannot be run off a rheostat
(variable resistor) or dimmer circuit, even if the rheostat or dimmer channel is used solely for a 0%
to 100% switch.
• Before applying power to a fixture, check that the source voltage matches the fixture's
requirement.
• All fixtures must be connected to circuits with a suitable Earth Ground.
ART-150W & ART-252W User Manual
7
Setup
S1
1
2005-01-31/12:52
Advertisement
Table of Contents
