Table of Contents
Advertisement
O
PERATING
Menu Navigation
To select any of the pre-set functions, press the MENU button until the desired function is shown on the
display. Select the function by pressing the ENTER button and the display will blink. Use the DOWN and
UP button to change the settings. Once the required setting has been selected, press the ENTER button to
activate it. If you don not press the ENTER button, it will automatically return to the main functions without
any change after idling 8 seconds. To go back to the functions without any change press the MENU
button. The main functions are shown below:
MENU
Upon powering up the unit, you will notice that it will display a fixture ID. In addition, the fixtures electronics
will load up its programming and home (adjust) its motors to a starting position. The sequence of events
should take no more than 20 seconds and it is necessary for the fixture to operate correctly. During this
time you will hear motor and mechanical movement inside the fixture. After this initial power-up sequence,
if the fixture receives no DMX signal, it will enter into a stand alone mode. Be sure to power up your DMX
controller device before the lighting fixture to avoid unwanted auto mode operation.
Operating Modes
All models can be operated in three different ways.
• Stand-Alone mode will allow the independent execution of programs and a Master/Slave mode will
allow the command of up to as many units you want in a synchronized manner.
• DMX control mode will provide the greatest flexibility and creativity. You can create an unlimited
range of chase patterns at any speeds
• Using the optional Spectrum Color™ dedicated controller.
ART-150W & ART-252W User Manual
I
NSTRUCTIONS
DMX 512 Addressing
Auto-color change show
Modes 1 through 4
Sh 1 = auto-color change 5 seconds
Sh 2 = auto-color change 10 seconds
Sh 3 = auto-color change 20 seconds
Sh 4 = auto-color change 1 minute
Manual blackout
Y bo = blackout / N bo = normal
Manual blackout
Y bo = blackout / N bo = normal
Focus Adjust
Self test
Fixture hours
Fixture reset
10
2005-01-31/12:52
Advertisement
Table of Contents
