Table of Contents
Advertisement
S
ETUP
Lamp
You will need to install a lamp prior to the initial operation of the fixture.
Warning!
When replacing the lamp, please wait 15 minutes after powering down to allow the unit
to cool down! Always disconnect from main power prior to lamp replacement.
Do not touch the envelope (glass area) of the bulb with bare hands. If this happens, clean the lamp with
alcohol and wipe it with a lint free cloth before installation.
L AM P I N ST ALL AT I O N ( ART - 15 0W )
1)
Remove the lamp back cover by
removing the 4 screws located on rear
of the head as illustrated.
2)
Remove the 4 corner screws so that
you can pull out the lamp socket plate.
3)
With lamp socket plate out and the
lamp accessible, if replacing the lamp,
remove old lamp first.
4)
Holding the new lamp by its base, align
the small pin on the lamp with the small
hole in the socket and insert the lamp
squarely until the retaining clips on the
lamp socket secures the lamp tightly.
5)
Clean the glass/envelope of the bulb
with an alcohol wipe or equivalent.
6)
Holding the lamp socket plate, insert
the tip of the lamp into the fixture with
extreme care. Navigate the lamp all the
way until it reaches the reflector and the
lamp base plate touches the bottom
plate of the fixture.
7)
Align the screw holes and fasten the screws back onto the lamp socket plate.
8)
If you are replacing the lamp, you may want to log the fixture hours in order to track the lamps use.
Navigate to the {FhrS} on the menu display to obtain this information.
9)
Turn the fixture on and adjust the lamp alignment screws until the brightest most even area of the
beam is in the center of your spot. It may be necessary for you to use a controller in order to
command the fixture to display a white beam. Conversely you can use the {} function from the
control panel instead of a controller. Visit the "Lamp Alignement How-To" section in this manual for
further reading and tips on the subject.
10) Place the lamp cover back on the fixture and screw on securely.
ART-150W & ART-252W User Manual
1
3
6
2
6,7
2005-01-31/12:52
Advertisement
Table of Contents
