Setup; Lamp; Lamp Installation; Power - Chauvet DMX-602 User Manual

S
ETUP

Lamp

You will need to install a lamp prior to the initial operation of the fixture. An ELC 250W halogen lamp
is included.
Warning! When replacing the lamp, please wait 15 minutes after powering down to allow the
unit to cool down! Always disconnect from main power prior to lamp replacement.
Do not touch the envelope (glass area) of the bulb with bare hands. If this happens, clean the lamp
with alcohol and wipe it with a lint free cloth before installation.
L AM P I N ST ALL AT I O N
1) Remove the screw located just above the fan at
the base of the fixture and proceed to slide the
lamp cover plate towards the bottom to expose
lamp.
2) If replacing the lamp, remove old lamp first.
3) Reach in and slide the lamp out of the retaining
cage.
4) Detach the lamp from the lamp socket and replace.
5) Replace lamp cover plate and fasten the screw.
6) No lamp alignment is necessary for this fixture
since the lamp is already optimized inside the
reflector.

Power

Warning! Verify that the voltage indicator label on your unit matches the line voltage applied.
All fixtures must be connected to circuits with a suitable Earth Ground.

To determine the power requirements for a particular fixture, see the label affixed to the back plate of the fixture or
refer to the fixture's specifications chart.
A fixture's listed current rating is its average current draw under normal conditions.


All fixtures must be powered directly off a switched circuit and cannot be run off a rheostat (variable resistor) or
dimmer circuit, even if the rheostat or dimmer channel is used solely for a 0% to 100% switch.
Before applying power to a fixture, check that the source voltage matches the fixture's requirement.


All fixtures must be connected to circuits with a suitable Earth Ground.
DMX-602 User Manual

Lamp Installation

Remove screw
6
Lamp
exposed
2006-02-10/12:12