Setup; Lamp Installation - Chauvet DMX MEGA STROBE III User Manual

3. S
ETUP

Lamp Installation

When replacing the lamp, please wait 15 minutes after powering down to allow the unit to cool down! Always disconnect
from main power prior to lamp replacement.
Note: The DMX Mega Strobe™ III ships with a lamp preinstalled.
Remove the 4 corner
screws to allow the
temporary removal of the
safety glass cover.
CH-750B Lamp
DMX MEGA STROBE™ III User Manual
Unscrew and release
lamp wires from the main
PCB.
The lamp is removed and replaced through the front of the
fixture. You must first remove the glass cover. Attempt to
remove the lamp after you have released all wire leads from the
PCB.
Remove the two Phillips#2 screws holding down each end of
the lamp.
Slide out the lamp wires from the reflector.
Repeat procedure in reverse to replace and reconnect wire
leads to the appropriate terminals on the PCB. Make sure that
the wires are tightly screwed onto the PCB terminals.
7
PCB
Unscrew grounding
wire from PCB.
6/11/2009 1:02 PM