FITTING REAR HOOK BRACKET
4. Engage a rear hook bracket with the lower tongue on its rear
latch plate, and retain to the roof with the Torx bolt. Use only
the special tool supplied, and do not fully tighten at this stage.
Ensure that the hook is fully located onto the tongue.
5. Repeat step (4) for the opposite rear hook bracket.
6. Push the roof fully forwards before tightening the front spigot
brackets using only the special Torx tool supplied. Hold each
rear hook bracket in alignment whilst tightening the single
fixing screw for each bracket. Do not overtighten.
oh_USA EliseExige E121.indd 93
h2
91
15/03/2010 15:08:10