Lotus ELISE 2007 Owner's Handbook Manual page 92

FRONT SPIGOT BRACKET
Hard Top - Fitting
1. Open both doors, and preferably with the aid of an assistant,
lower the roof onto the car holding aside the loose tethered
fixings to avoid their entrapment or their causing paint dam
age. Position the rear edge of the roof first before locating
the front edge against the windscreen header rail.
2. Locate a front spigot bracket into its latch plate lower slot
(lifting the roof slightly to allow this) and retain to the roof
with the Torx bolt. Use only the special Torx tool supplied in
the car tool kit (stowed in the battery cover pocket), and do
not fully tighten at this stage.
3. Repeat step (2) for the opposite front spigot bracket.
90
oh_USA EliseExige E121.indd 92
b330
15/03/2010 15:08:10