Troubleshooting - AEG DVD 4612 HC Operation Manual

Troubleshooting

Before sending the machine to the Customer Services, use the following table to check whether you can rectify the fault
yourself.
Fault
The power supply light
does not light
No image displayed on
screen
„bad" appears in the
display
No response when
pressing button
No sound
The remote control does
not work
DVD cannot be played
DVD4612HC_GB.indd 67 DVD4612HC_GB.indd 67
Possible cause
No power supply
No power supply/ mains switch
switched off
Video cable not correctly connected
No DVD/CD inserted
DVD/CD not compatible
DVD/CD incorrectly placed in
CD/DVD-tray
CD/DVD is dirty
CD/DVD is damaged
Incorrect settings
The child lock system is activated
The wrong TV mode has been se-
lected (no P-SCAN-capable playback
device).
DVD/CD not compatible
DVD/CD incorrectly placed in
CD/DVD-tray
CD/DVD is dirty
CD/DVD is damaged
Power supply problem or static
charging of appliance
Audio cable not connected
Amplifi er switched off
Incorrect settings
Volume on the DVD player turned
down.
wrong direction
too far away
Batteries empty
DVD has not been fi nalized
Solution
WARNING: Before troubleshooting, switch the player off.
Put the mains plug in correctly, if necessary, check the socket is
working with another appliance.
Switch the player on by the mains switch (Fig. 2/14).
WARNING: Before troubleshooting, switch the player off.
Check the correct fi t of the Video cable „Connecting the Video cable".
Make sure that the jacks are tightly in the sockets.
Insert a CD/DVD.
Use only compatible media (see „Technical data").
Turn the CD/DVD around.
Clean the CD/DVD around ➯ „Handling CD/DVD".
Use a different CD/DVD.
Check the settings of your DVD-Player.
Deactivate the child lock „Parental".
Press the STEP/P-SCAN button (Fig. 3/33) to change the TV
mode (Only possible in stop mode).
Use only compatible media (see „Technical data").
Turn the CD/DVD around.
Clean the CD/DVD around ➯ „Handling CD/DVD".
Use a different CD/DVD.
Switch off the main switch and pull out the mains plug. Insert the
mains plug into the socket and switch the player on again.
WARNING: Before troubleshooting, switch the player off.
Video plug for transmission of the Video signal, you must use and
Audio cable in addition to the Video cable ➯ „Connecting the Audio
cable".
If you use an amplifi er for Audio output: check whether the amplifi er
is switched on.
Check the settings of your DVD-Player.
Increase the volume by pressing the VOL+ key (Fig. 3/13).
The remote control is not pointed towards the DVD-Player.
Make sure that the remote control is not further than
5 m away from the player.
Replace the batteries in the remote control ➯ „Remote control battery
installation".
Use a fi nalized DVD.
Troubleshooting
67
14.09.2007 14:45:14 Uhr 14.09.2007 14:45:14 Uhr