Hyd-Mech S-20 A Manual page 22

intermediate screens to Machine Start screen (only active with Front Vise, Shuttle Vise,
and Head switches all in neutral).
- Press F1 function key labeled START. Hydraulics start and display change Manual
Mode.
- WASH will start the coolant pump.
- STOP will stop the hydraulic pump motor.
Front Vise, Shuttle Vise, and Head switches all become active and functional and cause
corresponding machine movements. Generally, at this point, use Manual Mode to position
material and make a trim cut Use HEAD switch to position head at desired head up limit.
- FWD Pressing this key will move the shuttle towards the front of the saw and will stop
and hold its position if the key is released.
- REV Pressing this key will move the shuttle towards the back of the saw and will stop
and hold its position if the key is released.
- SLW/FST Pressing this key will toggle SLOW /FAST cause the shuttle to move either
fast or slow.
- STOP will stop the hydraulic pump motor.
If Front Vise is switched to close, and HEAD is in neutral, then display switches to Single
point key.
Blade motor starts.
Press CYCLE pushbutton - display change to Single Cut in Progress. CYCLE IS ON
ing F3 key will cause the blade speed to increase until the key is released or the speed is
at the maximum (350 SFM). Pressing F4 key will cause the blade speed to decrease until
the key is released or the speed is at the minimum (70 SFM). The blade must be running
to use this key and the blade speed is shown on the display screen.
Use function key (F2) labeled COOL to start coolant pump.
If function key F2 labeled COOL is depressed for three seconds, then the display will
change to Coolant Select screen. If machine is equipped with optional mist coolant system
will select MIST coolant system and F2 will select FLOOD coolant system. Depressing F4
function key labeled EXIT will return to previous screen.
After a cycle has been started, it may be put into Pause by pressing the Cycle Start /
Pause button. Pressing the button again causes the cycle to resume. In Pause, all ma-
chine motions will stop, except blade will continue to run.
Single Cut Mode
2.6
MACHINE
START WASH
LTH xxxxxx"
FWD REV
ENTER LENGTH xxxxxx"
FWD REV
-
BLADE START xxxxxx"
FWD REV
CYCLE START xxxxxx"
FWD REV
L xxxx" CYCLE
-
STOP COOLoff
SELECTED FLOOD
MIST FLOOD
JOB IS PAUSED - TO
RESUME PRESS CYCLE
STOP
SLW STOP
SLW AUTO
SLW AUTO
SLW AUTO
+ S--- -
EXIT