Block Due To Non-Ignition; Block Due To Extraneous Light During The Pre-Purging; 8.10 Fuel Heating - Riello Gulliver BGK3 Installation, Use And Maintenance Instructions

8.9.2

Block due to non-ignition

Yellow
Signal not required
D7232
8.9.3 Block due to extraneous light during the pre-
purging
Yellow
Block due to extraneous light during the preheating
Yellow
Yellow
20013962
Green+Yellow
Green Red
Fig. 19
Green Red+Yellow
Block
Red
Fig. 20
Operation
Key to lay-out
F – Flame detector
I – Ignition transformer
K – Enabling switch thermostat for start up after preheating
LED – Signal of operation status from reset button
MV – Fan motor
PH – Diesel oil heater
TL – Limit thermostat
V1 – Oil valve
Red
Green + Yellow slow blinking
Green + Yellow fast blinking
Yellow
Green
Green + Yellow medium blinking
Red + Yellow fast blinking
Yellow fast blinking
Operating times
t1 max
t1I max
t2 -
t2I max
t2p max
t3 -
t3I max
The time is expressed in seconds

8.10 Fuel heating

In order to assure regular ignition and operation even at low tem-
peratures the burner has an oil heater fitted in combustion head.
The heater turns on when the thermostats close. The enabling
signal for burner start up comes through a thermostat on the noz-
zle holder once the optimal ignition temperature is reached. The
heating remains on during operation and cuts out when the burn-
er shuts-down.
D7231
20 GB
1 ts
30 t4i
3 t5i
30 t4I
600 t6
15 t6I
1 t7
- 5
- 8
- 3
max 1
max 360
max 30
- 120