3onedata IES615-2D Series Quick Installation Manual

IES615-2D Series
Managed Industrial Ethernet Switch
Quick Installation Guide
3onedata Co., Ltd.
Address: 3/B, Zone 1, Baiwangxin High Technology
Industrial Park, Xili,
Shenzhen
Website: www.3onedata.com
Tel: +86 0755-26702688
Fax: +86 0755-26703485
【Package Checklist】
Please check whether the package and accessories are intact
while using the switch for the first time.
1. Industrial Ethernet switch
3. Quick installation guide
5. DIN-Rail mounting attachment
If any of these items are damaged or lost, please contact our
company or dealers, we will solve it ASAP.
【Product Overview】
The series products are managed industrial Ethernet switch.
Models as follows:
Model I. IES615-2D (RS-232) (5 100M Copper Ports + 2
RS-232 Serial Ports）
Model II. IES615-1F-2D(RS-232) (1 100M Fiber Port + 4 100M
Copper Ports + 2 RS-232 Serial Ports）
Model III. IES615-2F-2D (RS-232) (2 100M Fiber Ports + 3
100M Copper Ports + 2 RS-232 Serial Ports)
Model IV. IES615-2DI (RS-485) (5 100M Copper Ports +2
RS-485/422 Serial Ports with Isolation)
Model V. IES615-1F-2DI (RS-485) (1 100M Fiber Port +4
100M Copper Ports +2 RS-485/422 Serial Ports with
Isolation)
Model VI. IES615-2F-2DI (RS-485) (2 100M Fiber Ports +3
100M Copper Ports + 2 RS-485/422 Serial Ports with
Isolation)
【Panel Design】

Top view, Bottom view and Rear view,
Nanshan District,

Front view
2. Certification
4. Warranty card
6 CD
Model I
【Mounting Dimension】
Model II Model III
1. DIP switch
2. Power input terminal block
3. Relay alarm output terminal block
4. Grounding screw
5. Location hole for wall mounting
6. DIN-Rail mounting kit
7. Power supply input status indicator PWR1/PWR2
8. Device running indicator RUN
9. Ethernet port status indicator
10. Serial port data receiving and sending indicator
11. RS-232 serial port
12. 10/100Base-T(X) 100M Ethernet copper port
13. 100Base-FX 100M Ethernet fiber port
14. RS-485/422 serial port
Unit: mm
Attention before mounting:
 Don't place or install the device in area near water or
moist, keep the relative humidity of the device
surrounding between 5%~95% without condensation.
 Before power on, first confirm the supported power
supply specification to avoid over-voltage damaging the
device.
The device surface temperature is high after running;
