Panasonic MX-V310 Operating Instructions Manual page 3

● This appliance is not intended for use by persons (including children) with reduced physical, sensory
or mental capabilities, or lack of experience and knowledge, unless they have been given supervision
or instruction concerning use of the appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not play with the appliance.
● Insert the Plug fi rmly.
• Otherwise it may cause electric shock and fi re caused by the heat that may generate around the Plug.
● Clean the Plug regularly.
• A soiled Plug may cause insuffi cient insulation due to moisture, and may cause fi re.
● When abnormal operation or breaking down occurs, discontinue the appliance operation immediately
and unplug.
Examples of abnormal operation or breaking down:
• The Plug or the Cord becomes abnormally hot.
• The Cord is damaged or there has been a power failure.
• The Motor Housing is deformed or abnormally hot.
→ Please unplug the appliance immediately and contact the service center for advice or a repair.
● Make sure to hold the Plug when unplugging. Never pull on the Cord.
● Be careful if hot liquid is poured into the Blender Jug as it can be ejected out of the appliance due to a
sudden steaming.
To prevent electric shock or fi re caused by short circuit,
● Do not leave the appliance unattended when it is in operation.
• When leaving the appliance unattended, turn the power OFF.
● Do not use the appliance in the following places:
• Any uneven surface, on non-heat resistant carpet, table cloth, etc.
• In a location where there is a risk of the appliance being splashed with water, or near a heat source.
● Do not blend more than 1.5 L working capacity marked on the Blender Jug.
● Do not place more than the maximum working capacity allowed for the Mill Container. Follow the
recommended ingredient amount for processing.
● Do not operate without the Blender Lid and the Inner Lid in place correctly for the Blender Jug.
● Ensure to operate and rest the appliance based on the table below:
Function
Blender
Wet & Dry Mill
● Unplug the appliance when not in use.
● When carrying the appliance, be sure to hold the Motor Housing with both hands.
● Switch off the appliance and disconnect from the power supply before changing accessories or
approaching parts that move in use.
● Care shall be taken when handling the sharp Cutting Blades, emptying the Blender Jug or the Mill
Container and during cleaning.
● Operate the appliance on a clean, fl at, hard and dry surface.
● If the Blender Cutting Blade gets stuck, switch off immediately and unplug. Do not insert fi nger into the
Blender Jug. Use the Scraper to remove the ingredients that are blocking the Blender Cutting Blade.
Blender_MX-V310_300 (EVT).indb 3 Blender_MX-V310_300 (EVT).indb 3
WARNING
CAUTION
or current leakage, burning, injury and smoke.
Operating Time
(minutes)
2
1
Rest Time
(minutes)
2
2
EN3
11/28/2017 6:30:58 PM 11/28/2017 6:30:58 PM