Transport And Storage; Transporting The Control Block/Control Block Segment; Transport By Hand; Transport With Lifting Gear - Bosch Rexroth SB24/34 Instruction Manual

52/78

Transport and storage

Bosch Rexroth AG, Control block SB24/34, RE 66170-B/2019-05-15
6 Transport and storage
▶ Always observe the ambient conditions required for transport and storage;
see chapter 6.2 "Storage of control block/control block segment" on page 53.
Deviations lead to early aging of components and shortening of service life.
Information on unpacking can be found in chapter 7.1 "Unpacking" on page 55.

6.1 Transporting the control block/control block segment

The following optional means of transport can be applied depending on the weight
and duration of transport:

• Transport by hand

• Transport with lifting gear (lifting strap)
The dimensions and weights vary by equipment. The values applicable for the
control block/control block segment can be found in the offer drawing and the
data sheet.
6.1.1 Transport by hand
Up to a specific maximum weight, control blocks/control block segments can
be transported by hand for a short distance. Observe the national regulations
in your country.
CAUTION! Risk of injury due to heavy loads!
When carrying control blocks/control block segments, there is a risk of injury.
▶ Only transport a control block/control block segment by hand for a short time.
Observe the national regulations for manual transport.
▶ Always use appropriate lifting, lowering and moving techniques.
▶ Use your personal protective equipment (e.g. safety goggles, safety gloves,
suitable working clothes, safety shoes).
▶ During transport, do not lift the control block/control block segment at sensitive
attachments (e.g., EHS actuating unit, sensors, solenoid coils).
▶ Carefully place the control block/control block segment on the surface to prevent
any damage.
6.1.2

Transport with lifting gear

For transport, the control block/control block segment can be attached to the lifting
gear by means of a lifting strap.
▶ Make sure that the lifting gear is sufficiently dimensioned for transport of the
control block/control block segment.
▶ Place the lifting strap around the control block/control block segment in
such a way that it does not pass over assembled parts (e.g. valves) and that
the control block/control block segment is not suspended at attachments.