Completion Of Assembly; Mechanical Connection Of The Control Block/Control Block Segment - Bosch Rexroth SB24/34 Instruction Manual

Installation 1.
Observe the requirements for the contact surface in the offer drawing.
2. Always attach the control block/control block segment at all dedicated
mounting points.
3. Tighten the mounting screws clockwise using a torque wrench in accordance
with Table 34.
Table 34: Tightening torques
Screw
M10
Fig. 5: Control block mounting
7.6.3

Completion of assembly

▶ Remove the transport protection.
If necessary, the control block/control block segment may be delivered with
protective covers and protective plugs. They are not pressure-resistant and
have to be removed prior to connection.
7.6.4

Mechanical connection of the control block/control block segment

Connection of actuation elements including tolerances is illustrated in the offer
drawing. The tightening torques are to be selected according to the actuation
elements. There must not occur any radial forces during actuation!
Tightening torque Minimum screw-in
depth of the thread
+8 Nm 15 mm
40
RE 66170-B/2019-05-15, Control block SB24/34, Bosch Rexroth AG
Installation 57/78
Through bore diameter Ø
11 +0.2 mm