Place cover with bolts 4 onto
grommets 3.
Move trim 2 forward in direc-
tion of arrow parallel to the rear
silencer.
The bolts 4 are placed in the
grommets 3 .
Fit the screw 1.
Calibrating ASC (
54).
Light sources
Replacing bulbs for low-
beam and high-beam
headlight
Make sure ground is level and
firm and place Maxi-Scooter on
its center stand.
Switch off ignition.
To replace the light source for
the low-beam headlight, re-
move the right-hand fairing
side panel.
To replace the light source for
the high beam, remove the
left-hand fairing side panel.
Replace the light source from
below. Removing the fairing
side panel improves the align-
ment.
Remove the cover 1 to replace
the light source for the high
beam.
Remove the cover 2 to replace
the light source for the low-
beam headlight.
8
105
z