BMW C 650 GT Rider's Manual page 104

Sensor cable wearing through
8
Make sure that sensor cable is
routed correctly.
102
Insert wheel speed sensor in
bore and install screw 1.
Remove adhesive tape from
wheel rim.
Firmly pull the handbrake lever
until the pressure point is per-
ceptible, and repeat this opera-
tion several times.
z
Mount front wheel cover and
install screws 1 and 2 on right
and left.
Calibrating ASC (
Removing rear wheel
Make sure ground is level and
firm and place Maxi-Scooter on
its center stand.
CAUTION
Hot exhaust system
Burn hazard
Do not touch hot exhaust
system.
Remove the screw 1.
54).
Move trim 2 backward in direc-
tion of arrow parallel to the rear
silencer.
Remove the bolts 4 from the
grommets 3.
Remove cover 2.