BMW C 650 GT Rider's Manual page 89

Install the spacer buffer 1 on
the left and right in the lower
position.
Loosen fastening screws 2 on
left and right.
Push mounts 3 on left and
right far enough apart that front
suspension fits between them.
Use locating pins 4 on left and
right to set front wheel stand to
desired height.
Center front wheel stand rela-
tive to front wheel and push it
against front axle.
Align two mounts 3 on left and
right so that front suspension
rests securely on them.
Tighten fastening screws 2 on
left and right.
ATTENTION
Lifting-off of the center stand
if the vehicle is raised too
high
Component damage cause by
tipping over
When raising the motorcy-
cle, make sure that the center
stand remains on the ground.
Adjust the height of the front
wheel stand if necessary.
Press down front wheel stand
evenly to raise Maxi-Scooter.
Ensure Maxi-Scooter is stand-
ing securely.
8
87
z