2.3 Microphone 2.4 Remote Control 2.5 Instruction sticker 3. Boot up 4. Operating JB-99RG 4.1 Basic operation of JB-99RG 4.2 Other functions 5. Programming bill acceptor 5.1 Password 5.2 Changing the price of a song 5.3 Setting the bill acceptor off 5.4 Setting the button control...
Next using the steel handles located on three sides, lift the JB-99RG unit out of the bottom holder and gently place it on the floor. Unlock the wheels on the bottom of the JB-99RG and roll the...
2.1.2 Attach the upper steel plate to the bottom of the TV monitor with 4 screws that came in a side pocket of JB-99RG. The upper steel plate is design to fit the bottom of the TV monitor in only one way with the 4 screw holes in line with the 4 screw holes of the TV bottom.
If so, place the multi-outlet into its position on the floor of the compartment and lock it in position by sliding it against its holders. 2.1.6 Connect the video RC cable on the top of the JB-99RG to the TV monitor Video In. 2.2 Mixer-Amplifier 2.2.1 Set all round knobs of the mixer-amplifier at the 12 o’clock (center) position...
JB-99RG. 3. Booting up Find a power cord in a side pocket of JB-99RG and connect it to the AC power socket on the back (bottom) of the JB-99RG. Plug the power cord into a wall power outlet of 110V.
Press the Power button on the TV monitor to turn it on. Change the channel to 1 for Video. Press the Power button on the front panel of the JB-99RG to begin the boot up process. This process will take approximately 30 to 50 seconds.
(#,$). 4.2 Other Functions Other functions available at the welcome screen of the JB-99RG are On Screen Songlist - Press the PgUp or PgDn button to display the songlist on the TV monitor and search forward or backward one page at a time.
To change the setting of the bill acceptor, you will need to enter a password. And when the JB-99RG is shipped, the password is preset as Pause - Pause - 7. Enter this password by pressing Pause, Pause, 7 onto the welcome screen.
CONTROL>> will appear on the TV monitor and the selections 1 and 2 will be preset to be “Disable”. WARNING: Selection 1 should always be set as “Disable”. Only when JB-99 digital player within the JB-99RG unit is removed outside should the selection 1 be set as “Able”.
From the <<SYSTEM CONTROL>> screen: o Press 4 to select “Free Credits”. Then use the Search (%,&) buttons to select the amount of free credits to be issue when the JB-99RG is powered on with a new boot up. o Press the Stop button to return to the welcome screen.
Step.4 will also work as usual. 6. Collecting bills 6.1 Open the steel case door on the right side of the JB-99RG using a key provided with the unit. Inside, there is a gray plastic box held attached to the bill acceptor.
Page 13
7.1 Enter the password to open <<SYSTEM CONTROL>> screen. 7.2 Select 6.Button Control to display the <<BUTTON CONTROL>> screen. Select 2 and use the Search (%,&) buttons to set the Button set #01 as “Able”. 7.3 Press the Stop button twice to return to the welcome screen. Then press the Menu button to enter into <<<FUNCTION>>...
8.1 Remove the top back panel by unscrewing 6 screws on the back of the JB- 99RG. 8.2 Insert a video RC cable through the circular hole on the top of the JB-99RG and connect the internal end to the Video In of the JB-99 and connect the external end to the Video Out of an external video source.
“Disable”. 8.10 Press the Stop button until the welcome screen is displayed. 9. Mixer-amplifier CAVS CA-242RA mixer-amplifier comes with many individual and independent controls for Mic1, Mic2, Echo, Music, and Master. For each of these categories, there are following controls:...
Increase or decrease the vocal volume level by adjusting the volume level controls of Mic1 and Mic 2 located on the back of the JB-99RG. If the volume level controls of Mic 1 and Mic 2 are past the 3 o’clock positions and...
Answer: Yes, using a video distributor, the video cable coming out from the top of the JB-99RG can be connected to 2 or more TV monitors simultaneously. A video distributor can be purchased from CAVS or any electronic stores such as Radio Shack.
Digital Jukebox enclosed in your JB-99RG unit. 11.4 How can the previous credits be erased? Answer: To erase the credit remaining in the JB-99RG, turn off and then on the bill acceptor from the <<SYSTEM CONTROL>> window. Please note that turning off and then on the JB-99RG unit will not erase the credit remaining.
Need help?
Do you have a question about the JB-99RG and is the answer not in the manual?
Questions and answers