Table B-1. Dial Commands - ADTRAN Async-232 User Manual

AT COMMAND LIST
Modem and Port Control
Modem and Port Control
Profile Configuration Control and Command Help
Command values with menu equivalents will not be changed based on AT com-
mand changes unless the profile is stored for the port (&W).
Dial Commands
Dial commands, their functions, and examples are given in Table B-1.
Command
ATDdialnum
ATDdialnum#P
ATDdial
string#P#C
ATDT and ATDP prefixes result in the same dialing behavior as ATD.
61200182L1-1
ATS
Access S-register
ATA Answer if autoanswer mode not enabled (see S0 register description)
AT Attention
ATH
Hangup in command escape mode
A/ Repeat last command
ATZ Reset. Hang up call if active and reset profile to current NVRAM settings.
ATO
Return online after command escape
&V2 Display AT command list help
&V Display this port's active and stored profiles
&F Restore factory default profile for port (does not save settings to NVRAM)
&W
Save current profile for this port to NVRAM

Table B-1. Dial Commands

Function
Dial out. Precedes the dial string. Protocol
and call type set in configuration menus.
Dial out using specified protocol which over-
rides configuration menu settings.
P=1 selects Analog Mode, P=2 selects ISDN
PPP.
Dial out using specified protocol and ISDN
digital call type.
P=2 as above selects ISDN PPP
C=1 selects Data 64K
C=2 selects Data 56K
C=3 selects Audio 3.1KHz
C=4 selects Speech
Async-232 Module User Manual
Appendix B. AT Commands
Example
ATDT5551212
ATDT5551212#1
ATDT5551212#2#3
B-3