Brother PE-DESIGN V7 Instruction Manual page 49

2
Insert an original card into the USB card
writer module.
a
Note:
The original card is inserted correctly when
you hear it snap into place.
3
Transfer the embroidery pattern.
Click File, then Write to Card.
→ The following message appears.
Click OK.
43
Tutorial
a
Note:
Before using the original card, make sure
that the designs on the card are no longer
needed or make sure to store them on your
hard drive or other storage media.
→ The following message appears.
Click OK.
a
Note:
• If the card writer module is not correctly
connected or powered, an error message
of "No card writer module is connected.
Please connect card writer module." will
appear.
• If the original card is not inserted or is
defective, an error message of "No
original card is inserted. Please insert an
original card." will appear.
4
Quit Layout & Editing.
Click File, then Exit.
b
Memo:
In Layout & Editing, the pattern is saved as a
.pes file.
To save the pattern, click File in Layout &
Editing, then Save as.