Installation Tools And Information; Installation Method; Setting The Camera; Setting The Video Output Type - Provision ISR I2-350A-28 User Manual

4.2 Installation Tools and Information

Prepare the required tools and instructions. Before
installation please prepare the following tools:
A straight or a Phillips-head screwdriver, multi-meter,
cutter, needle nose pliers, measuring tape, pencil.

4.3 Installation Method

1. Check the camera for any external damage.
2. Mount the bracket or base:
① For cement wall, install the expansion screws, and
then mount the bracket/base.
② For wooden wall use self-tapping screws to mount.
Note:
The wall needs to bear at least 3X weight of
bracket (base) and
method above is for reference only.

4.4 Setting the camera:

a. Dome Camera
Adjust the lens position so it aims at the main monitoring
point and gives a clear picture.
6
camera. Installation
b. Bullet Camera
Adjust the body so that the lens aims at the main
monitoring point and gives a clear picture. Tighten the
screws to ensure that it does not move.

4.5 Setting the video output type:

The camera supports AHD/TVI/CVI/CBVS video output.
And PAL/NTSC system is switchable by setting a DIP
switch on the cable as illustrated:
Note: DAI Models cannot switch between PAL/NTSC by
hardware. Chaning the output (AHD/TVI/CVI/CVBS) is
done by a switching button on the cable.
7