Brother PE-600II User Manual page 208

5 Pass the thread through the hole in the right of
the thread guide toward the back of the
machine.
1 Hole in the thread guide
6 Wind the thread clockwise around the bobbin
4 or 5 times, as shown in the illustration.
7 Pass the end of the thread through the guide
slit in the bobbin winder seat, and pull the
thread. The cutter will cut the thread.
1 Guide slit
2 Bobbin winder seat
1
8
9
2
1
Note
● Be sure to follow the procedure described.
If the bobbin is wound without the thread
being cut with the cutter, when the bobbin
thread runs low, the thread may become
tangled around the bobbin and cause the
needle to break.
Slide the bobbin holder, until it clicks into
place.
1 Bobbin holder
Press the main power switch to start winding
the bobbin.
Start winding the bobbin.
Using the Optional Bobbin Winder
1
7
191