Brother PE-600II User Manual page 189

APPENDIX —————————————————————————————————————————————————————
3 Pass the machine bed through the ring of the
cap frame driver.
1
1 Machine bed
Note
● Be careful that the cap frame driver does not
hit any nearby parts, such as the presser
foot.
Attach the cap frame driver to the carriage as
described below in steps
4 Insert the two thumb screws at the bottom of
the cap frame driver into the v-cuts in the
carriage, and then place the mounting plate of
the cap frame driver on top of the frame-
mounting plate of the carriage.
1 Notch in the carriage
2 Thumb screw of the cap frame driver
3 Mounting plate of the cap frame driver
4 Frame-mounting plate of the carriage
172
4 6
through .
3
4
2
1
Insert the pins on the frame-mounting plate of
5
the carriage into the holes in the mounting
plate of the cap frame driver.
2
1 Pins on the frame-mounting plate of the carriage
2 Holes in the mounting plate of the cap frame
driver
6 Insert and tighten the two upper thumb
screws in outer holes of mounting plate of cap
frame driver.
7 While pushing in the cap frame driver toward
the machine so that it is fully inserted, tighten
the two lower thumb screws to secure the cap
frame driver.
This completes the installation of the cap
frame driver.
1