Brother PE-600II User Manual page 190

Embroidery machine
Table of Contents

Advertisement

■ Adjusting the cap frame driver
1 L-shaped bracket
2 Ring
Memo
● If the same machine is being used, the
adjustment to the cap frame driver is only
required the first time that the machine is
used.
1
Turn on the machine. After the carriage
moves to its initial position, turn off the
machine.
Note
● Be sure to adjust the cap frame driver with
the carriage at its initial position.
2
Using the Allen screwdriver (medium), loosen
the two hexagonal screws. Loosen the screws
only by about one turn.
1 Hexagonal screws
2 Allen screwdriver (medium)
Note
● Do not loosen them too far.
3
Lower the L-shaped bracket to make it touch
the machine bed and then tighten the two
hexagonal screws using the Allen screwdriver
(medium). Firmly tighten the screws.
1 L-shaped bracket
4
Using the Allen screwdriver (large), loosen the
four hexagonal screws on the inside of the
ring. Loosen the screws only by about one
turn.
1 Hexagonal screws
2 Allen screwdriver (large)
When the screws are loosened, the ring can
be lowered.
Note
● Do not loosen them too far.
Using the Optional Cap Frame
7
173

Advertisement

Table of Contents

Troubleshooting

loading

This manual is also suitable for:

Pr-600iiPr600iiupg

Table of Contents