Troubleshooting - Brother PE-600II User Manual

Troubleshooting

If the machine does not operate correctly, check for the following points/issues before requesting service.
If the suggested remedy does not correct the problem, contact your authorized dealer.
Symptom
The machine is not turned ON.
The embroidery The machine has not been
machine does not unlocked.
operate.
The start/stop button was not
pressed.
The needle is not installed
correctly.
The needle set screw is loose.
The needle is bent or blunt.
The area around the hole in the
needle plate is damaged.
The needle
breaks.
The needle hits/touchs the
needle plate.
The presser foot is set too high
and not correctly positioned.
The needle hits/touches the
presser foot.
Probable Cause
1
1 Scratches/Burrs
1
2
3
1 Needle
2 Hole in needle plate
3 Needle hits hole
Remedy
Turn on the embroidery machine.
Touch the unlock key.
With the machine unlocked,
press the start/stop button.
Correctly install the needle.
Use the Allen screw driver to
securely tighten the needle set
screw.
Replace the needle with a new
one.
Replace the needle plate.
Consult your nearest authorized
dealer.
Replace needle.
Consult your nearest authorized
dealer.
Consult your nearest authorized
dealer.
Reference Page
p.20
p.42
p.42
p.63
p.63
p.15, 63
Troubleshooting 199
7