superbrightleds NFLSK-W600-VCT Instruction Sheet

Important: Read all instructions prior to installation.
Tunable White Flexible
Light Strip Kits
Parts Included
1 - 16.5' (5m) LED Flexible Light Strip
1 - Tunable White Controller with IR Remote
1 - 24VDC 48W CPS Power Supply
3 - Double-Sided Foam Pads
If your installation requires additional parts, visit superbrightleds.com and
enter the part number above in the search box.
Connecting Strips
(Method 1) Complete Kit Connection
Power Supply
(CPS-24VDC-48W)
IR Controller
Tunable White
Controller (VCT-CON)
Mode Selection
Mode Function
1 Warm White
2 Cool White
3 Natural White
4 Strobe Change
5 Fade Change
866-590-3533
(NFLS-W600-VCT)
(VCT-CON)
(CPS-24VDC-48W)
(3M-FTP)
Tunable White
600 High Power LED
Flexible Light Strip
(NFLS-W600-VCT)
Brightness Speed
Adjustable Not Adjustable
Adjustable Not Adjustable
Adjustable Not Adjustable
Adjustable Adjustable
Not Adjustable Adjustable
support@superbrightleds.com
Instruction Sheet
Part Number:
NFLSK-W600-VCT
Instructions
Pre-test & Configure
Remove strip from reel and make connections to power supply
and controller (see "Method 1" diagram). Breifly turn on strip
using the included remote controller to ensure proper operation
of the strip, power supply, controller, and remote.
Layout strip near surface of desired application, hold strip up
near mounting surface to determine the total length of the strip
needed for your installation. See below for cutting instructions
and cut off any excess strip.
See "General Diagram" for guide to installing and connecting
LED strip to included power supply and controller for your
application. Choose your desired yet suitable location for the
power supply and controller, routing IR sensor of controller to
convient line-of-sight location for general use with IR remote
control.
Ensure all installation surfaces are clean and dry.
Begin to remove strip's backing while adhering to desired
mounting surface. Press firmly to secure strips to surface. Route
strip around corners carefully, do not kink strip. Traces on the
circuit and other circuit components can be damaged if strip is
not adhered to surface carefully. Attach controller and power
supply to desired location using included foam tape.
Cutting
Cut strips to appropiate length using scissors
on lines indicated with scissor icon. Strip can
only be cut on these lines, which are spaced
every 12 LEDs.
IR Remote
ON/OFF
MODE
BRIGHTNESS
SPEED
IR remote controller has a signal range
up to 15ft (4.5m) and requires line-of-
sight to VCT-CON Variable Color Temp.
Controller.
Button Functions
Turn strip on and off,
retaining the last setting
Cycle through 3 static and 2
dynamic modes
Dim strip while on the
adjustable modes
Adjust dynamic mode
pattern speed.