Installing The Printer Driver; Setting The Printer Destination - Canon imageCLASS 2300 Network Manual

Installing the Printer Driver

In order to print, it is necessary to install the printer driver. (See Chapter 1, "Before
You Start Using This Machine," in the PCL Driver Guide.)
When the screen for selecting the printer destination is displayed during printer
driver installation, select [Local Printer]. Do not select [Network Printer].
The port selection can be changed after installation. You can select any port, such
as [LPT1].
IMPORTANT
•
If the IP address range settings do not permit the IP address, you cannot install a printer
driver.
•
If the IP address of the computer is beyond the range of the permitted addresses in the
IP Address Range Settings menu in the Remote UI, you cannot print from the computer.
4

Setting the Printer Destination

To set the printer destination, follow the procedure below.
1
2
4-4 Setting Up a Computer for Printing
Install the NetBIOS/NetBEUI Port Monitor utility from the
Network User Software CD-ROM provided with the machine.
❑
Insert the CD-ROM into the CD-ROM drive.
❑
Double-click the [My Computer] icon on the screen.
❑
Right click the CD-ROM drive icon ➞ click [Open] on the pop-up menu.
❑
Double-click the Portmon folder.
❑
Double-click the [Setup] icon.
In some environments, this icon appears as [Setup.exe].
The install program starts.
❑
Follow the instructions on the screen to complete the installation.
NOTE
Depending on the environment you are using, the CD-ROM menu may be
automatically displayed when you insert the CD-ROM into the CD-ROM drive. In
this case, click [End] ➞ perform the procedures in this step.
Open the Printer driver's Property dialog box.
❑
On the [Start] menu, point to [Settings] ➞ click [Printer].