Canon imageCLASS 2300 Network Manual page 36

5
Specify the setting method for the machine IP address.
To use [Use DHCP], [Use BOOTP], and [Use RARP] for the IP address setting,
select [On].
If selecting [Off] for [Use DHCP], [Use BOOTP], and [Use RARP], the machine
does not check the protocols.
If neither DHCP, BOOTP, nor RARP can be used, the IP address specified in [IP
Address] is allocated.
IMPORTANT
For this machine, in addition to direct allocation of the IP address to the machine,
you can use DHCP, BOOTP, or RARP to specify the IP address. When the machine
is started or reset, it checks whether DHCP, BOOTP, or RARP is being used, and
then allocates the IP address using the first available setting method.
NOTE
•
Checking whether DHCP, BOOTP or RARP can be used takes about 1 to 2
minutes; it is recommended you set unused protocols to 'Off'.
•
Depending on whether you use DHCP, BOOTP, or RARP to allocate the IP
address, you need to start the DHCP server, BOOTP daemon, or RARP daemon.
Protocol Settings 2-17
2