Printer Connection (Ipp); Windows 95/98/Me/2000/Xp - Canon imageCLASS 2300 Network Manual

NOTE
•
The admintool utility, SAM utility, and SMIT utility belong to the operating systems.
For specific operating instructions, see the operating system manual.
•
The above procedures are only examples. The setup procedures for your
environment may differ.
•
You can specify a print queue. The following three print queues are available (be
sure to use only capital letters to enter a print queue):
- LP: The machine prints according to its spool settings. Normally enter "LP" as a
print queue.
- SPOOL: The machine prints only after spooling a print job on the hard disk
regardless of its spool settings.
- DIRECT: The machine prints without spooling a print job on the hard disk
regardless of its spool settings.
The host computer settings are complete.

Printer Connection (IPP)

Windows 95/98/Me/2000/XP

1
Check the IP address range settings in the Remote UI to see
whether the IP address of the computer in which a printer
driver is to be installed is permitted. (See Chapter 2, "Remote
UI Functions," in the Remote UI Guide.)
IMPORTANT
•
If the IP address range settings do not permit the IP address, you cannot install a
printer driver.
•
If the IP address of the computer is beyond the range of the permitted addresses in
the IP Address Range Settings menu in the Remote UI, you cannot print from the
computer.
NOTE
For Windows 95/98/Me: Install the IPP Client software for Windows 95/98/Me
provided by Microsoft, and then restart your computer.
2
Start the Add Printer Wizard.
❑
On the [Start] menu, point to [Settings] ➞ click [Printers].
❑
Double-click the [Add Printer] icon.
Setting Up a Computer for Printing
2
2-33