GDC SR-1000 User Manual page 129

8. AUDIO PROCESSING
5 Connecting a Microphone
6 Connecting a Non-Sync source
7 Connecting an HDMI source
8 Connecting a Booth Monitor
IMPORTANT: Please check and set the levels of the analog input sources to the
AIB-2000 appropriately, to avoid any damage to the auditorium speakers.
USER MANUAL FOR SR-1000 STANDALONE INTEGRATED MEDIA BLOCK™
A Microphone can be connected to the MIC. IN on the
front panel of the AIB-2000 using a Male XLR
Connector.
*
If the microphone requires Phantom power, then press
the +48V button.
A Non-sync source can be connected to the NON-SYNC
IN on the front panel of the AIB-2000 using Male XLR
connectors or to the NonSync IN on the back panel
* using Male stereo RCA Connectors.
NON-SYNC front/back button switches Non-Sync input
between front XLR and rear RCA Connectors.
An HDMI source can be connected to the HDMI IN on
the faceplate of the SR-1000, using an HDMI cable.
AES pair 9/10 on the SR-1000 carries a mix of L+C+R
which can be used as a monitor output.
*
The AES pair 9/10 is available on the RJ45 Connector
labeled A-bot on the IMB and can be connected to the
Booth monitor via a D/A Converter.
- 128 -
* Refer to the AIB-2000 User Manual for more details.
nd
April 22 , 2021