Advertisement
F
T
IRES OF
RADITION
Step #8
The front plate of the Fenderfire can be
adjusted
inwards
loosening the 4 screws on the inside of
the frame. Insure that this plate lies flush
with the notched face of the base of the
4pc frame, as shown in the diagram.
You may need to repeat this step after
the install is complete.
Step #10
I
I
NSTALL
NSTRUCTIONS FOR
and
outwards
by
P
AGE
J
URASTONE
The riser of the 4 pc inner frame [JSUR
slip kit] can now be set into position,
and centered on the fireplace. Apply a
thin bead of cement along the bottom
edge of this riser, and carefully position
into position, centering it on the fire-
place.
A small pencil line on either side of the
riser will allow you to easily find the
right place once you have removed and
applied the cement to the bottom. Take
care to make sure that the riser is
pushed all the way back against the wall.
There should be no need to level the
riser seeing as it is placed on a level
hearth.
Step #9
At this point, it is good to do a dry fit of
the legs, side slips and beam to insure
that all parts are properly located. Posi-
tion the two legs first, then slide the slips
carefully into position to insure that the
back face of the slips fit up against the
front of the fireplace. A small gap here is
not a problem, as it quickly disappears
into shadows. The front Fenderfire plate
can be adjusted again if necessary.
8
21
OF
C
#4008
ORVALLIS
Advertisement
