Advertisement
F
T
IRES OF
RADITION
Note; The next step is frequently where
damage can occur! Make sure that the
beam is properly seated onto the top of
leg before letting go of it, as any
dropping of the beam against the top of
the legs can cause chipping.
Once both, left and right slips are in
position, apply a bead of cement on the
top edges of the legs, and along the two
back sides of the beam, and carefully
lower into position. Hold the beam away
from the back wall as it is lowered into
position, so as not to mark the wall.
I
I
NSTALL
NSTRUCTIONS FOR
Step #14
Step #16
P
10
AGE
OF
J
C
URASTONE
Carefully set one of the side slips into
position, by sliding it behind the inner
edge of the leg.
Note the edges that it comes in contact
with. Remove the slip, apply a thin bead
of cement along these edges, and set the
slip back into position. Wipe off any
extra cement with a wet cloth.
Step #15
Check the fit of the beam against the
top of the legs, and install another
wooden shim between the bracket and
the block on each side. This will hold the
beam against the wall in a secure man-
ner.
Check alignment of the joint where the
beam meets the top of the legs to insure
that the joint is good, and the leg is not
twisted.
21
#4008
ORVALLIS
Advertisement
