Advertisement
F
T
IRES OF
RADITION
The side slips must be cut down to 30
1/2" long in order to work with the
Ventana [there marks on the back of the
side slips indicating the cut marks]. This
can be done with any tile saw. Make sure
you have a good blade on the saw, and
carefully make your cuts.
one of the side slips into position, by
sliding it behind the inner edge of the
leg.
Note the edges that it comes in contact
with. Remove the slip, apply a thin bead
of cement along these edges, and set the
slip back into position. Wipe off any
extra cement with a wet cloth.
Step #13
I
I
NSTALL
NSTRUCTIONS FOR
Step #11
Gently set
P
18
AGE
J
C
URASTONE
This image is looking down inside the
leg. Take one of the wooden
supplied
in
the
carefully insert it between the block on
the inside top of the leg and the bracket.
This will help hold the leg against the
wall. Any extra cement can easily be
wiped off with a wet cloth.
There is a place for a second shim at
the bottom of the legs. Installing the sec-
ond shim may be done by reaching in
from the front bottom of the leg. This is
only
necessary
extremely out of vertical. Please use
your own discretion in placing the
second shim.
Step #12
Note: The next step is frequently where
damage can occur! Make sure that the
beam is properly seated onto the top of
leg before letting go of it, as any
dropping of the beam against the top of
the legs can cause chipping.
Once both left and right slips are in
position, apply a bead of cement on the
top edges of the legs, and along the two
back sides of the beam, and carefully
lower into position. Hold the beam away
from the back wall as it is lowered into
position, so as not to mark the wall.
21
OF
#4008
ORVALLIS
shims
blister
pack,
where
the
wall
and
is
Advertisement
