Table of Contents
Advertisement
Troubleshooting
PROBLEM
Motor Overheating/System
Tripping
(The motor's overload
will trip if the motor is
overheating)
Poor dust pick-up at Tools
Filter Clogging
System Lost Suction
If you continue to experience difficulty with your dust collector, call Oneida Air Systems' Customer Service
Ÿ
Department at 1-866-387-8822 or email support@oneida-air.com.
20
Oneida Air Systems, Inc.
C AUSE
Motor not properly wired
System and ductwork
connections
Dirty Filter
One of the three motors may
have reached its end of life
Air Leak
One of the three motors may
have reached its end of life
SOLUTION
1. Check wire connections.
2. Check breaker box to make sure power supply is correct for motor.
3. Check overload setting
1. Check hood design compared to ductwork design guidance.
2. Make sure all connections to the system are sealed. Large air losses will occur even
through small cracks in the flex hose. Use silicone or duct tape as a sealant.
3. Make sure everything is connected.
4. Check for air leaks around Longo cassette and cyclone.
5. Be sure that your filter is clean.
1. Replacements can be found in the Recommended Accessories section.
2. Review the Maintenance section on how to replace the motor.
3. Check for air leaks around Longo cassette and cyclone.
1. Replacements can be found in the Recommended Accessories section.
2. Review the Maintenance section on how to replace the motor.
Advertisement
Table of Contents
