Assembly Instructions (Continued)
Lift and close the Ring Clamp (F) over the
10
Barrel Gasket (B) and the Cyclone and Cart
Assembly's (G) upper flange.
Secure the Ring Clamp (F) using the Clamp's
cotter pin [FIG. 10].
Install a Cassette (I) into the Cassette Holder
11
(H) pushing it down so that it is snug and even
on all sides [FIG. 11].
Note: For ease of assembly, do not cut the ties
used to hold the Casette together until noted.
Installing the Cassette Holder (H) to the
12
Cyclone's Hopper (G) [FIG. 12a]:
a. Align the tabs on the Cyclone's Hopper (G)
with the cutouts in the Cassette Holder (H)
[FIG. 12b].
b. Raise the Cassette Holder (H) up until the
tabs are engaged [FIG. 12c].
c. Twist the Cassette Holder (H) counter
clockwise to lock it in place. [FIG. 12d]
12
Oneida Air Systems, Inc.
FIG. 10
FIG. 11
G
H
FIG. 12a
G
H
FIG. 12c
G
H
FIG. 12b
G
H
FIG. 12d