Oneida Air Systems CC500 Owner's Manual page 11

Assembly Instructions (Continued)
Place the Filter (E) on top of the Cyclone and
3
Cart Assembly (G) with the open side facing
down [FIG. 3].
Note: Position the Filter (E) on the Cyclone (G)
so that is centered between all four hex head
bolts.
Slide the Filter Hold-Down Plate (D) over the
4
Filter (E) and the installed bolts and secure in
place using four Nylock Nuts (C) [FIG. 4].
Note: Tighten hardware so that the Filter's pre-
installed foam gasket is firmly compressed (by
roughly 50%).
Open and slide the Ring Clamp (E) over the
5
assembly so that it rests outside the upper
flange of the Cyclone [FIG. 5].
FIG. 3
FIG. 4
E
F
FIG. 5
oneida-air.com
C
E
C
D
E
9