Advertisement
Troubleshooting
PROBLEM
Not separating well.
(Only a tiny amount of
dust should reach the
vacuum)
Material swirls in
cyclone and won't drop
into the dust container.
Material swirls in
cyclone and won't drop
into the dust container.
Low Air Volume
Drum Collapsing
Hose Pulling o
C AUSE
Air leaks in the drum
Collecting large bulky
material
System clogged
Blocked air ow
Hose connections not
tight
SOLUTION
1. Check for leaks between the lid and the dust drum.
2. Check for holes or leaks in the dust drum.
3. Check for leaks along the ange of the cyclone.
1. Large, bulkier material might swirl. Restart or temporarily cut
o air ow to drop material down.
1. Clean vacuum and the vacuum lter per the manufacturer's
specs.
2. Check all hose connections for a blockage in the hose.
1. Ensure at least one gate is open during operation of your dust
collector.
1. Due to the varied hose diameters, exible couplers can
be used. They are available at local hardware stores in the
plumbing section.
2. Use a hose clamp.
3. Wrap the inlet and outlet of the Dust Deputy with a layer of
electrical tape to increase the friction t.
4. Secure hose with a sheet metal screw.
oneida-air.com
19
Advertisement
