Assembly Instructions - Oneida Air Systems CC500 Owner's Manual

Assembly Instructions

Check to ensure that the Cotter Pin (G2) is
1
fully seated on the axle. [FIG. 1a].
Ensure that the Whiz-Lock Nuts (G4) holding
the Caster Wheels (G3) to the cart are securely
tightened [FIG. 1b].
Note: Remove the caps on the ends of the cart
legs to access the whiz-lock nuts. The caps are
pressure fit, no adhesive or silicone.
Ensure that the Cyclone and Cart Assembly
2
(G) is in the collapsed position by pressing
down on the foot pedal until the release latch
clicks in place [FIG. 2].
Note: Collapsing the unit will be more difficult
without the weight of the motor.
8 Oneida Air Systems, Inc.
G1
G2
FIG. 1a
FIG. 1b
Foot
Pedal
FIG. 2
G4
G3
Collapsed
Position