General Assembly Instructions - Oneida Air Systems Dust Cobra - XCK010000 Owner's Manual

V. General Assembly Instructions
If you are mounting the Dust Cobra to the optional
mobile cart, go to pg. 9.
1. Attach bracket to wall using
appropriate hardware for the sur-
face. We recommend using 5/16"
bolts to secure the bracket. If you
are using our 10 gal. steel drum,
you must mount the bracket at
least 34" from the fl oor to the top
back of the bracket. If not, adjust
height depending on the height of
your collection drum using pg. 4
for reference.
2. Put self-sticking gasket around inside rim on top of
cyclone as shown in photos. Be sure ends meet evenly
and there is no gap for air leakage.
3. Line up Hook clamp holes in front of cone and put the
two plastic spacers between the latch and cone. Fasten
with two pan head 3/4" screws provided by using two
Nylock nuts provided on the inside of cone.
6
4. Attach cone to wall
bracket by putting
supplied hex bolts
through side and bot-
tom holes as indicated
by diagram.
34"
Felt washer on cone
side bolt, then put
through bracket arm,
then 1 1/2" fender
washer, then secure
with thumb nut.
1.5" Bolt
Bottom bolt with
rubber washer
goes inside cone
then through and
is held by fender
washer and
thumb nut.
Small Larger
Rubber Felt
Washer Washer
Cone
Bracket Arm
Thumb Nut
1 1/2" Fender
Washer
Dust Cobra Owner's Manual O.A.S. 2010
c