Whirlpool WFC8090GX Use And Care Manual And Installation Instructions page 91

TROUBLESHOOTING
First try the solutions suggested here or please refer to the local service sheet that you will find
If you experience
Error Code Appears in Display
Once any possible issues are corrected, touch the POWER button once to clear the code. Re-select and restart the cycle.
F0E1
Load detected
in Clean Washer
with affresh cycle
F0E2
Oversuds detection
F0E3
Over temperature
on dry cycle
F0E4
Over temperature
on wash cycle
F0E5
Off-balance load
detected
F1E4
Main relay error
F3E1
Pressure sensor problem
F3E2
Wash NTC failure
F3E3
Air inlet NTC failure
F3E4
ADS error – sensors
F4E2
Dryer heater circuit failure
F4E3
Dryer blower motor failure
F5E1
Door lock/door switch
problem
F5E2
Door lock will not lock
F5E3
Door lock will not unlock
at the end of this manual for assistance and to possibly avoid a service call.
Possible Causes
Items detected in the washer/dryer
when running a Clean Washer with
affresh cycle.
Excessive suds in washer/dryer.
Washer/dryer is running a suds
reduction routine. Allow the wash
cycle to continue.
Dryer fan not functioning properly.
Wash water is too hot. Washer/dryer
may be connected incorrectly to the
home water supply.
Load could be unbalanced or too
large.
Problem detected with the main relay.
Problem detected with the pressure
sensor.
Problem detected with the wash NTC. Call for service.
Problem detected with the air inlet
NTC. The wash function is still
operable, but the dry function will
not operate.
Detergent level sensor error.
Problem detected with the dryer
heater circuit. The wash function
is still operable, but the dry function
will not operate.
Problem detected with the dryer
blower motor. The wash function
is still operable, but the dry function
will not operate.
Problem detected with the door
switch/door lock. Door is unlocked
during a cycle when it should be
locked.
Problem detected with the door lock.
Problem detected with the door lock.
Solution
Remove load and restart the Clean Washer with affresh cycle.
Use only HE detergent.
Try resetting the washer/dryer by unplugging it from the outlet
and then plugging it back in. If unsuccessful, call for service.
Make sure that the washer/dryer is connected to the cold
water supply only.
Avoid tightly packing the washer/dryer. Avoid washing single
items. Balance a single item with such as a rug or jeans with
a few extra items.
Try resetting the washer/dryer by unplugging it from the outlet
and then plugging it back in. If unsuccessful, call for service.
Try resetting the washer/dryer by unplugging it from the outlet
and then plugging it back in. If unsuccessful, call for service.
Call for service.
Clean the Load & Go bulk detergent dispenser,
or add detergent manually until dispenser is cleaned.
Call for service.
Call for service.
Try resetting the washer/dryer by unplugging it from the outlet
and then plugging it back in. If unsuccessful, call for service.
Try resetting the washer/dryer by unplugging it from the outlet
and then plugging it back in. If unsuccessful, call for service.
Try resetting the washer/dryer by unplugging it from the outlet
and then plugging it back in. If unsuccessful, call for service.
91