Level Washer/Dryer - Whirlpool WFC8090GX Use And Care Manual And Installation Instructions

2.
Clear water line
Run water for a few seconds through hose into a laundry
tub, drainpipe, or bucket to avoid clogs. Water should run
until clear.
3.
Connect inlet hose to washer/dryer
Attach hot water hose to hot water inlet valve. Screw coupling
by hand until it is snug. Use pliers to tighten couplings an
additional two-thirds turn.
IMPORTANT: To reduce risk of hose failure, replace the hose
every 5 years. Record hose installation or replacement dates
for future reference.
Periodically inspect and replace hoses if bulges, kinks, cuts,
n
wear, or leaks are found.
4.
Check for leaks
Slowly turn on water faucets to check for leaks. A small
amount of water may enter washer. It will drain later.
80
12.
Secure drain hose
Laundry Tub Standpipe
4.5"
4.5" 4.5"
(114 mm)
(114 mm) (114 mm)
Secure drain hose to laundry tub leg, drain standpipe, or inlet
hoses for wall standpipe with cable tie.

Level Washer/Dryer

IMPORTANT: Leveling your washer/dryer properly reduces
excess noise and vibration.
1.
Check levelness of washer/dryer
Place level here
on either side
Remove cardboard from beneath washer/dryer. Place a level
on top edges of washer/dryer, checking each side and front.
If not level, tip washer/dryer and adjust feet up or down as
shown in steps 15 and 16, repeating as necessary.
Not Level
Wall
4.5"
4.5"
(114 mm) (113 mm)
LEVEL Not Level