Whirlpool WFC8090GX Use And Care Manual And Installation Instructions page 88

Smart all-in-one washer and dryer
Hide thumbs Also See for WFC8090GX:
Table of Contents

Advertisement

Available languages

Available languages

TROUBLESHOOTING
First try the solutions suggested here or please refer to the local service sheet that you will find
If you experience
Wash Cycle Not Performing As Expected (cont.)
Not cleaning or
Not using correct cycle for fabric type.
removing stains
(cont.)
Not using dispensers/
dispensers not loaded properly.
Not washing like colors together.
Odors
Monthly maintenance not done
as recommended.
Not using HE detergent or using
too much HE detergent.
Door not left open after use.
Fabric damage
Sharp items were in pockets during
wash cycle.
Strings and straps could have tangled.
Items may have been damaged
before washing.
Fabric damage can occur if washer/
dryer is tightly packed.
Fabric damage can occur if washer/
dryer door is closed on an item,
trapping it between the door window
and the rubber seal.
88
at the end of this manual for assistance and to possibly avoid a service call.
Possible Causes
Use a warmer wash temperature to improve cleaning.
If using a What to Wash cycle selection paired with the "Quick"
How to Wash cycle selection, wash only a few items.
Use the "Heavy Duty" How to Wash cycle selection for tough
cleaning.
Add an extra rinse for heavily soiled loads.
Use dispensers to avoid fabric softener staining.
Load dispensers before starting a cycle.
Make sure that the Load & Go bulk dispenser liquid detergent
dispenser is not empty.
Avoid overfilling.
Do not add products other than those specified directly to load.
Wash like colors together and remove promptly after the cycle
is complete to avoid dye transfer.
Run the Clean Washer with affresh cycle monthly or every
30 wash cycles. See "Washer/Dryer Care" in the "All-In-One
Washer/Dryer Maintenance" section.
Unload washer/dryer as soon as cycle is complete. Use the
Tumble Fresh option if load cannot be removed immediately
after the wash is complete.
Use only HE detergent. Be sure to measure correctly. Always
follow the manufacturer's directions.
See the "Using the All-In-One Washer/Dryer" section.
This washer/dryer has a tight seal to avoid water leaks. To avoid
odors, leave the door open to allow the washer/dryer to dry
between uses.
Empty pockets, zip zippers, and snap or hook fasteners before
washing to avoid snags and tears.
Tie all strings and straps before starting wash load.
Mend rips and broken threads in seams before washing.
Avoid tightly packing the washer/dryer. Load with dry items only.
Use cycle designed for the fabrics being washed.
Add only one or two garments after washer/dryer has started.
Do not overfill the washer/dryer.
Push wash load fully into the washer/dryer.
Solution

Advertisement

Table of Contents
loading

Table of Contents