Plug In Washer/Dryer - Whirlpool WFC8090GX Use And Care Manual And Installation Instructions

2.
Rock washer/dryer to test foot contact
Grip washer/dryer from top and rock back and forth, making
sure all four feet are firmly on floor. Repeat, rocking washer/
dryer from side to side. If washer rocks, go to step 3 and
adjust leveling feet. If all four feet are in firm contact with floor,
go to "Plug In Washer/Dryer."
3.
Adjust leveling feet
Jam nut
If washer/dryer is not level, use a 1/2" (13 mm) open-end or
adjustable wrench to turn jam nuts clockwise on feet until
they are about 1/2" (13 mm) from the washer cabinet. Then
turn the leveling foot clockwise to lower the washer/dryer or
counterclockwise to raise the washer/dryer. Recheck levelness
of washer/dryer and that all four feet are firmly in contact with
the floor. Repeat as needed.
4.
Tighten leveling feet
Jam nut
When washer/dryer is level and all four feet are firmly in contact
with the floor, use a 1/2" (13 mm) open-end or adjustable
wrench to turn jam nuts counterclockwise on leveling feet
tightly against washer cabinet.

Plug In Washer/Dryer

WARNING
Electrical Shock Hazard
Plug into a grounded 3 or 4 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
1.
Plug into a grounded 3 or 4 prong
outlet
81