Whirlpool WFC8090GX Use And Care Manual And Installation Instructions page 77

3-Wire Power Supply Cord Strain Relief:
IMPORTANT: Use the strain relief supplied with the washer/dryer.
Attach power supply cord to strain relief
Put power supply cord through the strain relief. Be sure
that the wire insulation on the power supply cord is inside
the strain relief. Do not further tighten strain relief screws
at this point.
3-Wire Power Supply Cord Connection
Use where local codes permit connecting cabinet-ground
conductor to neutral wire.
3-wire receptacle
(NEMA type 10-30R)
Spade terminals
with upturned ends
3 prong plug
Ring terminals
1.
Connect neutral (center) wire
A
Connect neutral (center) wire (C) of power supply cord
under center terminal block screw (A). Tighten screw.
2.
Connect remaining wires
Connect remaining wires under outer terminal block screws.
Tighten screws and also tighten strain relief screws. Finally,
install terminal block cover and secure with the three screws.
Now, go to "Route Drain Hose."
C
77